How to install the base column of a single-column photovoltaic panel

How to install solar panels?

Instead just a simple steel pole with a concrete anchor is placed on the ground. This simple structure provides in general sufficient support to solar panels. In some cases, due to the unsuitable soil type or extreme weather conditions, special adjustments are required. Among the available pole mounted schemes, you will often find Side Pole Mounts.

How do you install a fiberglass column?

Fill the holes with epoxy per the manufacturer’s instructions. Insert the threaded rods in a twisting motion to ensure epoxy flows into the threads of the rods. Ensure that the rods are inserted to the proper depth and are plumb. Tip the aluminum column assembly onto its side and slide the fiberglass shaft over it.

How to install a PV system?

The first step is to carry out a survey of the geology of the land where the PV system will be installed. A bore test and tests to understand the soil conditions are essential to understanding the best type of foundation to use. You need to assess: These variables demonstrate how different sites can require different mounting structures.

How do solar panels attach to a roof?

The most common roof mounted structure of all. Consists of attaching a set of rails to the rooftop. Each solar panel is then attached to the rails through a set of clamps. The rails are secured to the rooftop by screws and bolts. This type of installation directly uses bolts and screws to secure each panel to the roof.

Are fixed base columns difficult to install?

The installation of fixed base columns can also be more difficult because of the additional plates on the column and anchor rods required. Fixed base columns must also be straight columns and are typically deeper at its base in comparison to pinned base. Typically fixed base columns are recessed below finished floor.

How do you install a beam on an aluminum column?

Install threaded rod into the top of the aluminum column assembly. For use with a single beam; slide the beam over the threaded rod and rest the beam on the top of the aluminum column assembly. Next, install a 1/4" x 2 1/2" x 2 1/2" washer, flat washer, and two hex nuts. Tighten to 30 ft. lbs.