Photovoltaic support z-shaped steel structure

Are ground mounting steel frames suitable for PV solar power plant projects?

In the photovoltaic (PV) solar power plant projects, PV solar panel (SP) support structure is one of the main elements and limited numerical studies exist on PVSP ground mounting steel frames to be a research gap that has not be addressed adequately in the literature.

How stiff is a tracking photovoltaic support system?

Because the support structure of the tracking photovoltaic support system has a long extension length and the components are D-shaped hollow steel pipes, the overall stiffness of the structure was found to be low, and the first three natural frequencies were between 2.934 and 4.921.

Which steel is best for PV mounting?

To do so, it requires a robust supporting structure made from high-quality steel with effective corrosion protection. With ZM Ecoprotect ® Solar, thyssenkrupp Steel now offering high-performance, zinc-magnesium-coated steels for PV mounting systems – durable, robust and sustainable.

What are the dynamic characteristics of photovoltaic support systems?

Key findings are as follows. Dynamic characteristics of tracking photovoltaic support systems obtained through field modal testing at various inclinations, revealing three torsional modes within the 2.9–5.0 Hz frequency range, accompanied by relatively small modal damping ratios ranging from 1.07 % to 2.99 %.

How many pillars does a photovoltaic support system have?

The tracking photovoltaic support system consisted of 10 pillars (including 1 drive pillar), one axis bar, 11 shaft rods, 52 photovoltaic panels, 54 photovoltaic support purlins, driving devices and 9 sliding bearings, and also includes the connection between the frame and its axis bar. Total length was 60.49 m, as shown in Fig. 8.

What are the mechanical properties of a tracking photovoltaic support system?

In terms of the mechanical properties of the actual components of the tracking photovoltaic support system, the bar element and shell element were used to simulate different components: beam elements were mainly used to simulate the axis bar, photovoltaic support purlins and pillars. Shell elements were used to simulate the photovoltaic panel.