Photovoltaic inverter driver chip

What are the requirements for a solar inverter system?

There are two main requirements for solar inverter systems: harvest available energy from the PV panel and inject a sinusoidal current into the grid in phase with the grid voltage. In order to harvest the energy out of the PV panel, a Maximum Power Point Tracking (MPPT) algorithm is required.

What auxiliary power does a Micro solar inverter need?

Figure 8. In a micro solar inverter, we need auxiliary power that can output multiple voltages to A/D sample circuits, drive circuits, MCU controller, and so forth. On the other hand, the auxiliary power must be completely isolated from primary side to secondary side.

How does a DC-DC Solar inverter work?

This solution implements an isolated DC-DC stage with the MPPT algorithm, to make use of the full capacity of the solar panel. The solar inverter maintains its input voltage at the reference set point generated by the MPPT algorithm, and delivers power to a downstream DC-AC inverter when connected across its output.

How do solar inverters work?

Curve moves with lighting condition, temperature, and so forth, just like Figure 4. Solar inverters must operate at the MPP to capture maximum energy from the PV panel. This is accomplished by the maximum power point control loop known as the maximum power point tracker (MPPT).

What is a solar microinverter system?

The term, “microinverter”, refers to a solar PV system comprised of a single low-power inverter module for each PV panel. These systems are becoming more and more popular as they reduce overall installation costs, improve safety and better maximize the solar energy harvest. Other advantages of a solar microinverter system include:

How much power does a solar microinverter support?

The solar microinverter is designed to support 215W out-put power at nominal input voltages (25 VDC-45 VDC). To ensure that the microinverter does not operate at an output power greater than 215W, a software clamp on the maximum allowable output current has been designed, based on the measured peak AC voltage.