How to install the H-type guide rail of the photovoltaic panel slider

How do I mount a PV module to a substructure?

MOUNTING INSTRUCTIONS PV modules can be mounted to the substructure using either corrosion-proof M8 bolts placed through the mounting holes on the rear of the module or specially designed module clamps. A clearance of at least 115mm(4.5in) (recommended) is provided between modules frame and the surface of the wall or roof.

How do I install a solar photovoltaic system?

Installing solar photovoltaic systems requires specialized skills and knowledge. Installation should only be performed by qualified personnel. Before installing a solar photovoltaic system, installers should familiarize themselves with its mechanical and electrical requirements.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

Can a racking system be used to ground a PV module?

This racking system may be used to ground and/or mount a PV module complying with UL 1703 only when the specic module has been evaluated for grounding and/or mounting in compliance with the included instructions. The system is a non-separately derived system.

Can JA Solar modules be installed on a roof?

JA solar modules have been listed as Class A according to IEC 61730-2 standard. For roof installations, modules should be mounted over a fire resistant covering suitable for this application, with adequate ventilation between the modules backsheet and the mounting surface. Roof constructions and installations may affect the fire safety of building.

Do JA Solar modules need a grounding conductor?

The grounding is only used on the framed bifacial modules. JA Solar modules use an anodic oxidized aluminum frame to resist corrosion. So the frame of modules must be connected to the equipment grounding conductor to prevent thunder and static hurt.