Photovoltaic soft crystal panel installation method diagram

How do I install a solar photovoltaic system?

Installing solar photovoltaic systems requires specialized skills and knowledge. Installation should only be performed by qualified personnel. Before installing a solar photovoltaic system, installers should familiarize themselves with its mechanical and electrical requirements.

What is included in a solar installation manual?

This installation manual contains important electrical and mechanical installation information as well as safety information that you must be familiar with, providing important safety instructions for the installation, use and maintenance of solar modules.

Which direction should a photovoltaic module be installed?

When installing photovoltaic modules in the northern Hemisphere, the optimal installation direction of the module is to face south; When installing photovoltaic modules in the Southern Hemisphere, the optimal installation direction of the module is to face north. Serial connected PV modules should be installed in the same orientation and Angle.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

Where can I find Electrical and mechanical characteristics of crystalline silicon PV modules?

Detailed electrical and mechanical characte-ristics of Canadian Solar Inc. crystalline silicon PV modules can be found in Annex C (Mechanical and Electrical Ratings) on Main electrical characteristics at STC are also stated on each module label.

How to install a photovoltaic light fixture?

The fixture shall be installed within the scope authorized by Suntech. The inside side of the fixture and the side of the photovoltaic module should be completely fitted. In any fixture installation mode, the fixture must not touch the glass or deform the frame of the bracket or module.