Photovoltaic inverter fault code diagram

What are solar inverter error codes?

Solar inverter error codes notify you of a situation threatening the normal operation of your solar power system. Many different things can go wrong and disrupt electricity generation from a solar PV system. The inverter will detect it and generate corresponding error codes to notify you.

How to check if a PV inverter is faulty?

Check PV input Current (PV Over current) 2. Restart inverter by recycling both AC and DC switches. Wait for 1 minute between OFF and ON for all energy to discharge. If inverter cannot clear fault, replace inverter. Recommended solutions: 1. Measure voltage at DC terminals in wire-box and compare with reading in Measurement menu.

Why is my PV system not feeding into my inverter?

If this message is repeated frequently, contact the SMA Service Line. The inverter has detected a ground fault in the PV array. As long as the fault exists, the inverter will not feed in. Check the PV system for ground faults ( > Checking the PV System for Ground Faults). The PV array voltage is too low.

What causes a solar inverter to fail?

Inverter failure can be caused by problems with the inverter itself (like worn out capacitors), problems with some other parts of the solar PV system (like the panels), and even by problems with elements outside the system (like grid voltage disturbances). An inverter failure is when the inverter develops faults that cause improper functioning.

Can a PV inverter be touched?

Touch the cables of the PV array on the insulation only. Do not touch any parts of the substructure or frame of the PV array. Do not connect PV strings with ground faults to the inverter. Ensure that no voltage is present and wait five minutes before touching any parts of the PV system or the product.

What happens if a PV inverter fails?

The inverter will be shut down automatically if the PV power generation system fails, such as output short circuit, grid overvoltage / undervoltage, grid overfrequency / underfrequency, high environmental temperature or internal malfunction of the machine. The fault information will be displayed on the APP interface.