Installation of photovoltaic panel column hole opener

How do I install a solar photovoltaic system?

Installing solar photovoltaic systems requires specialized skills and knowledge. Installation should only be performed by qualified personnel. Before installing a solar photovoltaic system, installers should familiarize themselves with its mechanical and electrical requirements.

Can a photovoltaic module be installed outside?

Photovoltaic modules are designed for outdoor use. Modules may be mounted on ground, rooftops, vehicles or boats. Proper design of support structures is the responsibility of the system designers or installers. Mounting holes or clamp range and numbers suggested in this manual shall be used.

How to connect Alko PV modules?

Adjacent modules may be side connected by placing the wire into the secondary beam. AlKO modules are designed certified according to IEC-61215 and IEC-61730. Modules are designed with safety class ll and fire class rating C. Before to handle and install AIKO PV module, read carefully and understand this Installation Manual.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

What conditions should a solar PV module be installed in?

Risen module should be installed in the following environmental conditions. -20°C to+50°C. Remarks: The working environment temperature is the monthly average maximum temperature and minimum temperature of the installation site. The mechanical load bearing capacity of the solar PV module is determined based on the installation method.

How to ground a solar PV module?

On a grounding hole with a diameter of φ4 mm, use a separate grounding wire and related accessories to connect the aluminum frame of the solar PV module and connect the grounding wire to the ground. The grounding uses the M4 x 12mm bolts and M4 nuts, star washers and plain washers, this ensures that the modules are firmly grounded.