Photovoltaic panel frame disassembly diagram

How do I mount a PV module to a substructure?

MOUNTING INSTRUCTIONS PV modules can be mounted to the substructure using either corrosion-proof M8 bolts placed through the mounting holes on the rear of the module or specially designed module clamps. A clearance of at least 115mm(4.5in) (recommended) is provided between modules frame and the surface of the wall or roof.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

Do PV modules have a switch?

Any contact of 30V or larger DC Voltage can be fatal. In case of no connected load or external circuits, modules can still produce voltage. Please use insulation tools and wear rubber gloves when operating modules in the sunlight. The PV modules do not have a switch.

Do PV modules need to be connected to ground?

PV module installation site is exposed to long-term humid conditions such as floating PV system. To reduce the risk of PID, on the modules DC connection site, it is recommended to connect the negative to ground. As part of the module design, an anodized corrosion-resistant aluminum alloy frame is used to provide rigidity.

What happens if a PV module is exposed to sunlight?

PV module connectors pass direct current (DC) when exposed to sunlight or other light sources. Contact with electrically active parts of the module, such as terminals, can result in injury or death, irrespective of whether or not the module and the other electrical equipment have been connected.

What happens if you disconnect a photovoltaic module?

Contact with a DC voltage of 30V or more is potentially hazardous. When disconnecting wires connected to a photovoltaic module that is exposed to sunlight, an electric arc may result. Such arcs may cause burns, may start fires and may otherwise create problems. Therefore, be extremely careful!