Rural solar bracket installation drawings

Are solar racking systems UL/ANSI 2703 compliant?

Solar Stack systems have been evaluated for module-to-system bonding and mechanical load to the requirements of UL/ANSI 2703. This racking system may be used to ground and/or mount a PV module complying with UL 1703 only when the specic module has been evaluated for grounding and/or mounting in compliance with the included instructions.

Are solar stack roof mounting systems ul 2703 listed?

Solar Stack Roof mounting systems are UL 2703 listed. Standard for safety UL/ANSI 2703, Mounting Systems, Mounting devices, Clamping/Retention Devices and Ground lugs for use with PV modules. Solar Stack systems have been evaluated for module-to-system bonding and mechanical load to the requirements of UL/ANSI 2703.

Can a racking system be used to ground a PV module?

This racking system may be used to ground and/or mount a PV module complying with UL 1703 only when the specic module has been evaluated for grounding and/or mounting in compliance with the included instructions. The system is a non-separately derived system.

What are the components of a solar stack pedestal system?

The system is a non-separately derived system. The following components have been evaluated for bonding as the fault current ground path: PV module, Mid Clamp, End Clamp, Pedestal and Ground Lugs. Solar Stack pedestals can be installed on BUR (Build Up Roong), Mineral surface (Modied Bitumen), EPDM, PVC, TPO, Hypalon and Concrete roofs.

What is the Sun approach angle for a ballasted roof mount?

The sun approach angle of the Ballasted Roof Mount system varies depending upon the amount of ballast required for your installation and whether or not Wind Deflectors are utilized. The sun approach angle for most installations will be 17 degrees. The row spacing for this system is 21.97 inches (module to module).

Who should install a solar panel?

All electrical installation and procedures should be conducted by a licensed electrician or solar contractor. Routine maintenance of a module or panel shall not involve breaking or disturbing the bonding path of the system. All work must comply with national, state and local installation procedures, product and safety standards.