Photovoltaic support inclined beam size specification

What is the design angle of a fixed photovoltaic module?

The software SAP2000 has strong functions, design of the fixed photovoltaic support. Japan. The deg ee of the design angle of PV modules was ×991 mm×40mm. The single photovoltaic array unit was arranged into 4 row s and 5 column s. According to the basic parameters were shown in table 1.

What are the characteristics of a cable-supported photovoltaic system?

Long span, light weight, strong load capacity, and adaptability to complex terrains. The nonlinear stiffness of the new cable-supported photovoltaic system is revealed. The failure mode of the new structure is discussed in detail. Dynamic characteristics and bearing capacity of the new structure are investigated.

How many pillars does a photovoltaic support system have?

The tracking photovoltaic support system consisted of 10 pillars (including 1 drive pillar), one axis bar, 11 shaft rods, 52 photovoltaic panels, 54 photovoltaic support purlins, driving devices and 9 sliding bearings, and also includes the connection between the frame and its axis bar. Total length was 60.49 m, as shown in Fig. 8.

What are the dynamic characteristics of photovoltaic support systems?

Key findings are as follows. Dynamic characteristics of tracking photovoltaic support systems obtained through field modal testing at various inclinations, revealing three torsional modes within the 2.9–5.0 Hz frequency range, accompanied by relatively small modal damping ratios ranging from 1.07 % to 2.99 %.

How stiff is a tracking photovoltaic support system?

Because the support structure of the tracking photovoltaic support system has a long extension length and the components are D-shaped hollow steel pipes, the overall stiffness of the structure was found to be low, and the first three natural frequencies were between 2.934 and 4.921.

What is the tilt angle of a photovoltaic support system?

The comparison of the mode shapes of tracking photovoltaic support system measured by the FM and simulated by the FE (tilt angle = 30°). The modal test results indicated that the natural vibration frequencies of the structure remains relatively constant as the tilt angle increases.