Zhongao Wind Turbine Generator Instructions

How to install a wind turbine Anemoscope?

Position the anemoscope on the anemoscope bracket by bolts. The place where anemoscope will be installed should be square and near the wind turbine generator. It should be vertical against the ground with the height less than the generator. Please refer to the users’ manual for tower for the detailed tower erecting procedures. dry air.

How to install a wind generator?

Hang up the wind generator by crane or chain block together with triple-angle stand. Make sure the section. (three-phase wires, without identifying positive and negative electrodes). turbine”. Connect these three wires to the generator rear terminal marking “generator input” (three-phase wires, without identifying positive and negative electrodes).

How to assemble a wind turbine generator?

3.2 Procedures to assemble the wind turbine generator. for 3KW & above models) from the tower bottom to the tower end by using the thin steel wires. Hang up the wind generator by crane or chain block together with triple-angle stand. Make sure the section. (three-phase wires, without identifying positive and negative electrodes). turbine”.

How do you connect a wind turbine charge controller?

Connecting the charge controller to the battery before connecting it to the wind turbine will prevent power spikes from forming. This, in turn, will prevent damage to your equipment. Connect insulated wire to the charge controller. This wire will transfer power from the generator to the charge controller.

How do you make a wind turbine rotor?

Place your lower magnet rotor onto the studs. You can either make your upper and lower magnet rotors with a rotor plate, epoxy, and 2" by 1" by ½" neodymium magnets, or you can buy this part prefabricated as part of a wind turbine kit or from a wind turbine part manufacturer.

Can you build a wind generator from scratch?

So now being a well equipped DIYer its time to built the first wind generator from scratch. The whole idea is to built a small wind generator using relaible techniques and the stuff thats best suited to serve the purpose while gathering all the material from the hardware store or a junkyard. Well time to get our hands dirty.