Great Wall Fengjun generator installation diagram

Can a master electrician install a generator transfer switch?

Master electrician Heath Eastman helps a homeowner install a generator transfer switch in his home. While extension cords might do the trick, there’s a better and safer way to run a generator when the power is out—transfer switches. Master electrician Heath Eastman helps a homeowner install a set in his home.

What are the NFPA guidelines for installing a generator?

Based on this testing and the requirements of NFPA 37, Sec 4.1.4, the guidelines for installation of the generators listed above are changed to 18 in (457 mm) from the back side of the generator to a stationary wall or building (C).

How do you reinforce a generator compartment?

An alternate reinforcement method is to place No. 6 reinforcing bars on 12 inch (300mm) centers hori-zontally. Bars should clear the foundation surface a minimum of 3 inches (75mm). Retain the generator compartment to the concrete slab with masonry bolts.

How do you tighten a generator lug?

Insert power wires (E1 and E2) into their corresponding lugs. Tighten to required specification. Verify factory-installed ground array and neutral connections are properly tightened to 25 in-lbs (2.82 Nm). NOTE: Neutral wire must remain connected to keep the battery charged whether the generator is running or not.

How do you hook up a generator?

Plug in your generator to the hookup. Match the holes at the end of the generator's cord to the prongs on your hookup. Then, plug it in. You’ll likely have to turn the plug (usually about 15 degrees) to complete the connection to your hookup. Plug your attachment cable into your generator.

Where should a generator exhaust be piped?

Exhaust gases must be piped safely away from any building or enclosure that houses the generator to an area where people, animals, etc., will not be harmed. This exhaust system must be installed properly, in strict compliance with applicable codes and standards.