Great Wall Fengjun 7 generator installation diagram

Can I use a 5ft pre-wired conduit on a portable generator?

Do not install the 5ft. pre-wired conduit if you are using the ULTRA SOURCE portable generator for back up power. 11a. Remove the knock out at the bottom left of the external connection box.

What are the NFPA guidelines for installing a generator?

Based on this testing and the requirements of NFPA 37, Sec 4.1.4, the guidelines for installation of the generators listed above are changed to 18 in (457 mm) from the back side of the generator to a stationary wall or building (C).

How do you reinforce a generator compartment?

An alternate reinforcement method is to place No. 6 reinforcing bars on 12 inch (300mm) centers hori-zontally. Bars should clear the foundation surface a minimum of 3 inches (75mm). Retain the generator compartment to the concrete slab with masonry bolts.

Where should a generator exhaust be piped?

Exhaust gases must be piped safely away from any building or enclosure that houses the generator to an area where people, animals, etc., will not be harmed. This exhaust system must be installed properly, in strict compliance with applicable codes and standards.

How do I know if a generator is NFPA compliant?

Verify fuel pressure NEVER drops below the required specification once the generator is installed. See the NFPA website at for further information regarding NFPA requirements. Always consult local fuel suppliers or the fire marshal to check codes and regulations for proper installation.