Lefeng generator installation tutorial diagram

What are the NFPA guidelines for installing a generator?

Based on this testing and the requirements of NFPA 37, Sec 4.1.4, the guidelines for installation of the generators listed above are changed to 18 in (457 mm) from the back side of the generator to a stationary wall or building (C).

How do you install a stand-by generator?

In this video, This Old House host Kevin O’Connor explains how to install a stand-by generator. Steps: 1 Install electrical sub-panel with transfer switch beside the main electrical panel. 2 Redirect critical circuits from main panel to sub-panel. 3 Prepare a level stone or concrete base for the generator. 4 Set generator on base.

How do I install a new language on my Generator?

Generator Active is displayed on the LCD screen when the unit is first powered up. After displaying firmware and hardware version codes, as well as other system information, the Install Wizard is launched, and the Language screen is displayed. Use UP ARROW or DOWN ARROW to scroll to desired language. Press ENTER.

How do you tighten a generator lug?

Insert power wires (E1 and E2) into their corresponding lugs. Tighten to required specification. Verify factory-installed ground array and neutral connections are properly tightened to 25 in-lbs (2.82 Nm). NOTE: Neutral wire must remain connected to keep the battery charged whether the generator is running or not.

How do you connect a generator to a ground lug?

Connect the Ground wire to the Ground Lug and torque to the required specification. See Figure 6-1. NOTE: Neutral Bonding - For installations that require the neutral to be bonded to the ground, this is to be done on the customer connections terminals inside the generator. Connect a suitably sized wire from the neu-tral bar to the ground bar.

How do I set up a generator MLCB?

Set generator MLCB (generator disconnect) to ON (CLOSED). Verify both auxiliary shutdown switches are ON (I). Press AUTO on control panel. System is now ready for automatic operation. Turn off utility power supply to transfer switch.